Electrolux CX-L-410-Serie Montage- Und Gebrauchsanweisung Seite 27

•
rotate the filter 60° in the direction opposite to the one shown in the picture, the carbon
filter will release the joint in alu;
•
grasp the filter and pull this far from its housing;
•
repeat the above for the other filter.
If you have a wall cooker hood (FIG.7), see par. 3.3.
If you have a island cooker hood with external chimney (FIG.10), see par 3.4.
3.3 MOUNTING THE HOOD TO THE WALL
3.3.1 PREPARATION OF THE DECORATIVE CHIMNEY ATTACHMENTS
To mount the decorative chimney, it is necessary to arrange for a ceiling attachment.
The support bracket is of such a shape that it can be fixed to the ceiling or the side wall (SEE
FIG. 7).
To fix the bracket, proceed as follows:
•
decide exactly where on the ceiling (or on the wall), the support bracket for the chimney is
to be fitted;
•
make support and safety fixing holes with a drill;
•
fit the screw plugs in the holes;
•
fit the screws in the plateholes and in the plugs;
•
tighten the screws with a screwdriver.
3.3.2 FIXING TO THE WALL
To fix the hood to the wall, proceed as follows:
•
based on the technical drawing, mark the position of the support and safety fixing holes
on the wall with a pencil, in such a way that the base of the hood is at the distance from
the cooker hob, as indicated in par. (2.1) and that it is horizontal. Mark the position of the
holes with a pencil making a small cross on the wall.
•
drill the support and safety fixing holes in the positions marked;
•
fit the metal hooks to the support holes (see FIG.8) complete with plug and screws,
completely inserting the plastic plug and keeping the curved part on the outside and
facing downwards; in the safety fixing holes only insert the plastic plug;
•
tighten the support screws;
•
rest the back of the hood on the wall and insert the hooks into the corresponding slots;
•
make sure the hood is stable;
•
holding the cross notched screwdriver in your hand; slowly tighten the horizontal
alignment screws one at a time, until the hood is perfectly horizontal above the cooker
hob. The use of a level will help in this operation;
•
insert the screws into the safety holes;
•
tighten the safety holes with the screwdriver.
3.3.3 MOUNTING OF THE SCAVENGING PIPE
If the hood is to be used as a suction hood, to apply the pipe proceed as follows:
•
measure the distance to be covered by the pipe and obtain parts of the right size;
•
insert the hood outlet mouthpiece into the pipe and block it;
•
connect the lengths of pipe up to the hole towards the outside;
•
connect the pipe to the end which goes outside;
•
make electrical connection (see par.4).
3.3.4 MOUNTING OF THE DECORATIVE CHIMNEY
The decorative chimney shown in FIG. 7 is composed of 2 parts of metal sheet which slide
one inside the other. To mount the chimney please proceed as follows:
•
the 2 parts of the chimney are mounted as shown in FIG. 7;
•
position the base part of the chimney with holes matching the ones on the hood;
•
insert the screws if available, on the bottom of the chimey and fix them;
•
let the telescopic part of the chimney slide to the height necessary to touch the ceiling and
come into contact with the chimney bracket;
•
tighten the screws on the chimney bracket to the ceiling.
27