Siemens KI S Serie Gebrauchsanleitung Seite 49

Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
A warning signal sounds and the alarm button is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food were placed in the
appliance.
Display flashes, warning signal sounds and button alarm is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food were placed in the
appliance.
Display flashes.
The temperature in the freezer compartment was
too warm.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the after-sales service.
~ "Customer service" on page 50
Press the alarm button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Do not exceed max. freezing capacity.
Press the alarm button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Do not exceed max. freezing capacity.
When button alarm has been pressed, the warmest
temperature reached in the freezer compartment is
displayed for 5 seconds. Press the alarm button.
The display stops flashing.
Start the appliance self-test.
~ "Appliance self-test" on page 50
When the programme has ended, the appliance
switches over to normal operation.
Faults – what to do? en
49