Parts Identification; Operating Instructions; Installing Or Removing Battery Cartridge; Charging - Makita DF011D Bedienungsanleitung

PARTS IDENTIFICATION

1. LED light
2. Forward / reverse selector and On/Off switch
3. Screwdriver bit holder
4. Battery cartridge

OPERATING INSTRUCTIONS

WARNING!
Do not overcharge the battery. Recharge only when the tool starts to run slowly.
CAUTION:
• Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function
on the tool.

1. Installing or removing battery cartridge

1
• Always switch off the tool before insertion or removal of the battery cartridge.
• To remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge.
• To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into
place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
• Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted
correctly.

Charging

1. Plug the battery charger into the proper AC voltage source. The charging light will flash in green color.
2. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their
respective markings on the charger.
3. When the battery cartridge is inserted fully, the charging light will change from green to red and charging will begin.
The charging light will remain lit steadily during charging.
4. When the charging light changes from red to green, the charging cycle is complete.
5. After charging, unplug the charger from the power source.
Refer to the table for the charging time below.
Battery type
Li-ion battery cartridge
6
Voltage
Number of cells
1
3
7.2 V
Capacity (Ah)
2
BL7010
4
Charging time
(minutes)
1.0
2
30