Operating The On/Off Switch; Turning On The Front Lamp; Using The Folding Handle - Makita DF011D Bedienungsanleitung

3. Operating the On/Off switch

The On/Off switch is used to start the screwdriver. It also controls the direction in which the bit holder rotates.
Forward
(Driving)
4
1. To rotate the bit holder in a forward (driving) direction, press the right hand side of the On/Off switch marked
figure 4.
Reverse
(Removing screws)
5
2. To rotate the bit holder in a reverse (removing screws) direction, press the left hand side of the On/Off switch marked
. See figure 5.
3. Release the On/Off switch to stop the screwdriver.
NOTE:
Always use sharp good quality screwdriver bits. The performance and safety of the screwdriver is dependant on the
quality of the bits used.

4. Turning on the front lamp

Lamp
6

5. Using the folding handle

7
8
CAUTION:
• Do not look in the light or see the source of light directly.
Press the switch to turn on the light. The lamp keeps on lighting
while the switch is being pressed.
The screwdriver is equipped with a folding handle for either in-
line, or pistol grip use. When folded into the pistol grip position it
gives assistance when used in areas that may have restricted
access. See figure 7.
To use the folding handle, grip the lower handle with one hand
and move the upper handle to the desired position with the other
hand.
. See