Mounting Profile Tube - walterscheid SW40 Bedienungsanleitung

7.2

Mounting profile tube

1. Deburr the profile tube all round on the face
of the press fitting side.
2. Insert the profile tube into the clamping
profiles.
3. Grease the protrusion of the profile tube
(Fig. 23).
4. Move the profile tube (1) by hand in the
direction of the inboard yoke (2) so that the
profile tube securely engages in the inboard
yoke.
5. Clamp the profile tube tightly in the clamp-
ing profiles.
6. Check the alignment of the profile tube with
the inboard yoke again. If necessary, adjust
the inboard yoke so that no twisting occurs
during the press fitting.
7. Move the mounting carriage (3) forward
until the bore holes (4) and (5) of the
•
profile tube (1) and the inboard yoke
(2) are aligned.
until the profile tube (1) engages flush
•
in the receptacle of the inboard yoke.
8. If necessary, drill a hole from both sides
through the bore holes of the inboard yoke
into the profile tube.
9. Drive in the clamping pin.
10. Undo the clamping lever screws (6).
11. Keep turning the threaded rod until the
counter bearings (7) and the clamping lever
(8) release the inboard yoke (2).
12. Release the profile tube in the clamping
profiles.
The drive shaft halves can now be removed
®
from the special tool.
Fig. 22
Fig. 23
39