Replacing Profile Tube; Removing Profile Tube - walterscheid SW40 Bedienungsanleitung

REPLACING PROFILE TUBE

7 Replacing Profile Tube
7.1

Removing profile tube

1. Install the appropriate clamping profiles (1).
2. Select the appropriate profile size for hold-
ing the profile tube.
3. Move the mounting carriage (2) (see chap-
ter 6.3) forwards in the direction of the
counter bearing (3) so that the hydraulic cyl-
inder (4) is almost completely extended.
4. Insert the profile tube (1) into both clamping
profiles (2) so that the bore hole (3) of the
inboard yoke (4) faces upwards.
5. Support the joint (5) using the support (6).
6. Guide the joint (5) with one hand.
7. Keep turning the threaded rod (7) until the
counter bearings (8) for the guidance of the
inboard yoke are just against the area of the
guard bearing running groove (do not clamp
tight).
8. Align the two clamping levers (1) opposite
the grooved yoke (2) so that the clamping
levers securely support the inboard yoke.
9. Tighten the clamping lever screws (3) hand
tight (do not tighten firmly) so that both
clamping levers (1) lightly contact the in-
board yoke (2).
® The inboard yoke can still easily be turned
by hand.
Fig. 18
Fig. 19
Fig. 20
37