Operating The Special Tool; Mounting Clamping Profiles; Clamping And Releasing Profile Tubes In The Clamping Profiles - walterscheid SW40 Bedienungsanleitung

OPERATING THE SPECIAL TOOL

6 Operating the Special Tool
6.1

Mounting Clamping Profiles

1. Pull the locking pin (1) up and hold.
2. Pull the clamping profile (2) out of both
supports (3).
3. Insert the clamping profile with the tapered
surface (4) in front into the supports (3).
4. Lock the required profile size for both
clamping profiles using the locking pins (1).
6.2

Clamping and releasing profile tubes in the clamping profiles

Clamping profile tubes in the clamping pro-
files
1. Turn the changeover screw (1) to the ON
position.
2. Operate the manual lever (2) until the
clamping profiles (3) clamp the profile tube
firmly.
Releasing profile tubes in the clamping pro-
files
1. Turn the changeover screw (1) to the OFF
position.
® Both clamping profiles slacken and release
the profile tube.
34
Always use 2 clamping profiles of the same type.
Fig. 13
Fig. 14