Intended Use; Danger Zone And Danger Points - walterscheid SW40 Bedienungsanleitung

2.3

Intended Use

2.4

Danger zone and danger points

The WALTERSCHEID special tool SW40 for profiles of drive shafts is
exclusively intended for the dismantling and mounting of yokes / joints
of and on profile tubes by qualified skilled personnel. The special tool
is only permitted to be operated by the hydraulic hand pump supplied
by us or using the pneumatically driven hydraulic unit supplied by us.
Proper use also includes:
the compliance with all instructions in this operating manual,
•
the compliance with the specified work for maintenance and care
•
of the special tool,
the exclusive use of original parts.
•
Any uses other than those above are prohibited and are deemed as
improper use.
For damage arising from improper use:
the owner bears the sole responsibility,
•
the manufacturer accepts no liability of any kind.
•
The danger zone is the area surrounding the special tool in which
hazards for the safety or health of persons can arise during the hy-
draulic movement of the mounting carriage.
No persons are permitted to be in the danger zone during the hydrau-
lic movement of the mounting carriage.
The operator is only permitted to move the mounting carriage hydrau-
lically if there are no persons in the danger zone of the special tool.
There are hazards in the danger zone from danger points which can-
not be completely eliminated with respect to the functional safety of
the special tool. The hazards are always present.
Danger points on the special tool are identified with warning signs.
The warning signs warn about the residual risks.
Action-related safety instructions in this operating manual indicate the
existing residual risks of the special tool.
11