Cleaning, Maintenance And Repairs - walterscheid SW40 Bedienungsanleitung

SAFETY INSTRUCTIONS
3.4.3

Cleaning, maintenance and repairs

22
Carry out the specified work for cleaning, maintenance and re-
•
pairs at the specified intervals.
Any mechanical, hydraulic or pneumatic residual energies pre-
•
sent can initiate unintended movements of the special tool.
Note the presence of residual energies in the special tool for
maintenance and repair work. Warning signs identify compo-
nents with residual energies. Detailed information can be found
in the respective chapters of this operating manual.
Secure all operating media such as hydraulic oil and com-
•
pressed air against unintended start-up.
Check the tightness of bolts and nuts regularly. Tighten loosened
•
bolts and nuts.
Check whether threaded connections loosened for cleaning,
•
maintenance and repairs have been tightened again.
Check the function of safety devices and protective equipment
•
after completion of the maintenance work.
Dispose of oils, greases and filters properly.
•
Handle and dispose of substances and materials used for clean-
•
ing the special tool properly, particularly:
for work on lubrication systems and equipment,
o
when cleaning with solvents.
o
Spare parts must comply at least with the specified technical
•
requirements of the manufacturer. This is always the case when
original parts are used.
Observe the intervals for the maintenance of wear parts.
•