Operation; Charging; Switching On And Off - Kobold VC100 Gebrauchsanleitung

Placing the charging unit
on a level surface
Connecting the mains cable
4 9
10
7
8
b
2. Position the charging unit on the wall so that the designated
opening fits over the screw.
• You can also position the charging unit on a level surface.
1. Plug the mains cable (9) into the designated charging socket (10)
on the underside of the charging unit (4).
11
2. This is done by feeding the mains cable (9) through the
designated cable guide (11) and the cable aperture (12).
12
6

Operation

6.1 Charging

1. Ensure that the handheld vacuum cleaner is switched off before
every charge.
2. Connect the mains charger to the power supply.
4
3. Place the handheld vacuum cleaner onto the charging unit (4).
4. If you want to charge the handheld vacuum cleaner using the
cable rather than the charging unit, firmly press the pin (a) on
the charging unit to open it.
5. Insert the small plug (b) on the mains charger into the
corresponding jack on the handle of the handheld vacuum
cleaner.
6. Then plug the mains charger into the power socket.
a

6.2 Switching on and off

• Press the green button (8) to switch the handheld vacuum cleaner
on and off.
25