Ext Setting; Hyper Sound - JVC AV32X25EU Bedienungsanleitung

Using the TV's menu
BBE
You can use the BBE function to enjoy easy-
to-listen sound that is faithful to the original
sound recorded.
ON:
This function is turned on.
OFF:
This function is turned off.
Licensed by BBE Sound, Inc. BBE is a
registered trademark of BBE Sound, Inc.

HYPER SOUND

You can enjoy sounds with a wider
ambience.
ON:
This function is turned on.
OFF:
This function is turned off. The menu
disappears.
• The HYPER SOUND function does not
work properly with mono sound.
• You can turn on or off the HYPER
SOUND function with a single press. For
details, see "HYPER SOUND function"
on page 12.
SPEAKER
(Excluding AV28CH1EU)
You can turn off the sound from the TV
speakers; but you should only do this if an
audio system is connected to the TV as a
substitute for the TV speakers.
ON:
The TV speakers issue sound.
OFF:
The TV speakers does not issue sound.
• The 5 buttons of the TV remote
control and the r (volume) buttons at
the front panel of your TV set can be used
to control the volume of each speaker
simultaneously.
• Setting the volume of the amplifier too
high may damage the front speakers.
22
Downloaded from www.Manualslib.com manuals search engine

EXT SETTING

EXT SETTING
EXT-1
EXT-3
EXT-4
TV
BACK
TV OK
D0020-EN
S-IN (S-VIDEO input)
When connecting a device (such as S-VHS
VCR) which enables an S-VIDEO signal (Y/
C signal) to be output, you can enjoy high-
quality picture of the S-VIDEO signal (Y/C
signal).
Preparation:
• At first, read the Device Instruction
Manual and "Additional preparation" on
page 36 to connect the device to the TV
properly. Second, follow the Device
Instruction Manual to set the device so
that an S-VIDEO signal (Y/C signal) can
be output to the TV.
• Do not set S-IN (S-VIDEO input) to the
EXT terminal connected to a device
which cannot output an S-VIDEO (Y/C
signal). If it is set wrongly, a picture
cannot appear.
1 Choose an EXT terminal
2 Press the yellow button and set the
S-IN (S-VIDEO input).
Then press the a
An S-IN (S-VIDEO input) mark is
displayed. You can view an S-VIDEO
signal (Y/C signal) instead of the regular
video signal (composite signal).
DUBBING
EXT-2
ID LIST
S-IN
a button
a a