Electronic Adjustment - AEG FAVORIT 55000 VI0P Benutzerinformation

24 www.aeg.com

Electronic adjustment

1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode. Refer to
'SETTING AND STARTING A PRO-
GRAMME'.
2. Press and hold function buttons (B)
and (C) at the same time until the in-
dicators of function buttons (A), (B)
and (C) flash.
3. Press function button (A).
• The indicators of function buttons
(B) and (C) go off.
6.2 Filling the salt container
6.3 Filling the rinse aid dispenser
A B
A
-
+
C
D
• The indicator of function button (A)
continues to flash.
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
• The display shows the setting of
the water softener, e.g.
5.
4. Press function button (A) again and
again to change the setting.
5. Deactivate the appliance to confirm.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3.
Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
Remove the spilled rinse aid with an
3.
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between
position 1 (lowest quantity) and
position 4 (highest quantity).
= level