Requirements For The Installation Location; Electric Connection - Graef T 6 Bedienungsanleitung

Universal Slicer Tendenza T 6 / T 7 / T 9 / T 16
important!
If possible, save the original
►
EN packing during the unit's
warranty period to be able
to properly pack the unit in
case of a warranty claim.
Requirements for the in-
stallation location
For safe and flawless operation
of the unit, the place of location
must meet these prerequisites:
The unit must be set up on a
■
firm, flat, level and non-slip
base that has sufficient load
bearing capacity.
Select the place of location so
■
that children cannot reach the
sharp blade in the unit.

Electric connection

Follow these instructions about
the electrical connection for safe
and flawless operation of the
unit:
Before connecting the unit,
■
compare the connection infor-
mation (voltage and frequency)
on the rating plate with those
of your electrical network. This
information must match to
avoid damage to the unit. If in
doubt, ask your electrician.
Make sure that the connecting
■
cable is not damaged. Do not
conduct it over hot surfaces or
sharp edges.
■ The connector cable must not
20
be pulled tight.
■ The electrical safety of the unit
is only ensured if it is connected
to a properly installed protective
conductor system. Operation
on a socket without a protec-
tive conductor is prohibited. If in
doubt, have the building instal-
lation checked by an electrician.
The manufacturer does not
assume any responsibility for
damages caused by a missing
or interrupted protective con-
ductor.