Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Universal Slicer Master Classic C 6 / Classic C 6
Returning the packing to the ma-
terials circuit saves raw materials
and reduces the accumulation of
EN
waste. Dispose of packing material
that is no longer needed at a col-
lection point for the »Green Point«
recycling system.
important!
If possible, save the original
►
packing during the unit's warran-
ty period to be able to properly
pack the unit in case of a war-
ranty claim.
Requirements for the in-
stallation location
For safe and flawless operation of
the unit, the place of location must
meet these prerequisites:
■
The unit must be set up on a
firm, flat, level and non-slip base
that has sufficient load bearing
capacity.
Select the place of location so
■
that children cannot reach the
sharp blade in the unit.
Electric connection
Follow these instructions about the
electrical connection for safe and
flawless operation of the unit:
■
Before connecting the unit, com-
pare the connection information
(voltage and frequency) on the
rating plate with those of your
electrical network. This informa-
tion must match to avoid dam-
age to the unit. If in doubt, ask
20
your electrician.
■
Make sure that the connecting
cable is not damaged. Do not
conduct it over hot surfaces or
sharp edges.
The connector cable must not be
■
pulled tight.
The electrical safety of the unit
■
is only ensured if it is connected
to a properly installed protective
conductor
system.
on a socket without a protec-
tive conductor is prohibited. If in
doubt, have the building instal-
lation checked by an electrician.
The manufacturer does not as-
sume any responsibility for dam-
ages caused by a missing or in-
terrupted protective conductor.
Operation
Werbung
Inhaltsverzeichnis
