Information On Start-Up - Schulte U-3003-E Gebrauchsanweisung

Information on start‐up
1. Assemble nebulizer as described (page 7, 10 or 11).
2. Check whether the mains voltage and power information on the
nameplate (rear of the device) correspond to your mains power supply.
Plug the mains cable into the mains socket on the rear of the device and
connect with the mains power supply.
3. Check whether there is enough distilled water in the transducer head
(6) (blue marker).
4. Switch the device ON at the main switch (7) on the rear. Press the
ON/OFF button (10) on the control panel and start nebulization. The
green "operation" indicator lights up.
5. You can adjust the following values on the control panel (9):
Parameter
Aerosol quantity
Air flow
Pictogram
page 8
Settings
step 1 to 5
step 1 to 5