Connecting Analyzer To Computer - Stihl MDG 1 Gebrauchsanleitung

Insert the power supply unit in a wall
N
outlet.
A self test runs when the engine
analyzer is connected to the power
supply.
B
A
0/
During this process the light emitting
diode (1) on the engine analyzer glows
green, then yellow, then red and then
continuously green – end of self test.
Light emitting diode (1) glows
continuously red: internal fault – replace
analyzer.
Light emitting diode (2) flashes white:
Analyzer ready for operation – no
connection to computer – check
connection.
ADG 1 Battery Analyzer
Mains voltage and operating voltage
must be the same.
MDG 1
2
3
Insert the mains plug (1) in the wall
N
outlet (2).
The following information is displayed
1
(shown with gray background):
Battery Analyzer
ADG 1
A self test runs when the analyzer is
connected to the power supply. During
this process the light emitting diode (3)
on the analyzer lights up green for about
1 second, then red and goes off again.
Self test
Connecting Analyzer to
Computer
2
1
Bluetooth Connection
Bluetooth wireless technology is used to
transmit information between the engine
analyzer and the computer. A free USB
port on the computer is required for the
Bluetooth USB stick supplied with the
analyzer.
LEDs, Colors, Meanings
A
LED (1)
Glows green, then
yellow, then red
and then continu -
ously green:
Glows continuously
green:
Glows continuously
red:
English
2
B
0/
1
Meaning
Self test completed
Ready for
operation
Internal fault –
replace analyzer
19