Campingaz CAMPING KITCHEN 2 Bedienungsanleitung Seite 12

appliance - back facing the wind - so that
GB
the wind does not deviate the burner flame
outside the base of the saucepan.
- When cooking is finished turn the knob
corresponding to the burner clockwise to
•
position ( ).
Important: never close the appliance lid
without checking that all the burners are
off, the valves closed and the appliance has
cooled down.
3) Switching off
- Close the regulator or gas cylinder valve.
- After the flames have gone out, close
the stove valves by putting the knobs in
•
position ( ).
F - REMOVING OR CHANGING THE
GAS CYLINDER
- Check that the gas cylinder valve or
regulator lever is in the closed position.
- Place the adjusting knobs in position (
turning them clockwise.
- Disconnect the regulator from the gas
cylinder.
- Install the new gas cylinder.
- Connect the regulator to the new gas
cylinder (check the condition of the
regulator seal, before connecting it to the
gas cylinder).
G - STORAGE - SERVICING
a) Stove
Ensure that your stove is regularly maintained,
and it will give you many years of excellent
service.
- Do not clean the stove while it is in operation.
Wait for it to cool down, to avoid burning
yourself on the hot parts (pan supports,
burners).
- Clean the greasy parts with soapy water or
a non-abrasive detergent;
(Do not use a scouring pad or abrasive
products).
- For easier cleaning the pan supports can
be washed in a dishwasher.
- If the appliance has not been used for over
30 days verify that there are no spider's
webs blocking the burner tube, which can
reduce the efficiency of the appliance
or cause dangerous combustion of gas
outside the burner.
- Store the packed stove in a dry, well-
ventilated place.
b) Flexible hose or hose between the
regulator and the stove
- Check the condition of the piping periodically
and change it if it shows signs of ageing or
cracks or when national conditions require
it.
- In France, if the expiry date printed on
the flexible pipes is reached, the flexible
pipe with collars must be replace by an
assembly complying with Standard XP D
36-110.
- Follow the assembly instructions supplied
with these new assemblies, whose length
•
must be a maximum of 1.50 m, and the
) by
procedure described in paragraph B).
If you do not plan to use your stove for a
long period, disconnect the gas cylinder.
- 12 -