Miele Complete C3 SG 3 Serie Gebrauchsanweisung Seite 48

en
If the suction power of the adjustable
floorhead seems too high, reduce the
suction until the floorhead is easier
to manoeuvre (see "Use - To regulate
the suction power").
Using the SID Intensive floorhead
(depending on model)
Please observe the flooring manu-
facturer's cleaning and care instruc-
tions.
The SID floorhead is designed for brief
use on carpets, and for vacuum flooring
with deep gaps and crevices.
For continuous vacuuming we recom-
mend using the adjustable floorhead.
Inserting batteries into the LED
handle (dia. 10 + 11)
(depending on model)
 Loosen the screw on the cover.
 Press in the sides of the cover to re-
lease the retainers and remove the
cover.
 Take out the battery holder and in-
sert the three batteries supplied.
Make sure the polarity is correct.
 Refit the battery holder. Arrows are
marked on the battery holder and
battery compartment as a fitting aid.
They should point in the same direc-
tion.
 Replace the cover and tighten the
screw back up again.
48
Activating the exhaust filter
TimeStrip® change indicator on the
exhaust filter
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
12).
a AirClean
b AirClean Plus 50 (light blue)
c Silence AirClean 50 (grey)
d Active AirClean 50 (black)
e HEPA AirClean 50 (white)
If your vacuum cleaner is fitted with fil-
ter c,d or e, you need to activate the
exhaust filter TimeStrip® change indic-
ator.
 Press the release catch for the dust
compartment lid and raise the lid as
far as it will go (dia. 13).
 Remove the indicator strip (dia. 14).
 Press the exhaust filter TimeStrip®
change indicator (dia. 15).
After approx. 10 - 15 seconds, a thin
red line will appear in the left hand side
of the display (dia. 16).
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
How the exhaust filter TimeStrip
works®
The exhaust filter TimeStrip® change
indicator shows the remaining func-
tional life of the exhaust filter. After ap-
prox. 50 operating hours the display will