Switching On And Off; Working With The Lawnmower; Cleaning, Maintenance And Storage - Grizzly Tools ARM 2033-22 Lion Set Originalbetriebsanleitung

The correct height is around 25 – 45 mm
for a decorative lawn and around
45 –65 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Observe noise control and local
regulations.

Switching On and Off

1. Place the mower on a level sur-
face.
2. Lift the battery cover (6) of the
device housing and insert the
charged battery (7) along the
guide rail into the device. It
clicks audibly into place.
3. Close the transparent cover (6)
again.
4. Insert the safety key (20) in the
corresponding opening (20a)
above the rechargeable battery.
5. Before switching on, ensure that
the equipment is not in contact
with any objects.
6. To switch on, press the power
switch (17) and hold it down
while pressing the safety
switch (18) against the bow-type
handle (1). Release the power
switch (17).
7. To switch the apparatus off, let
go of the security switch (18).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.
Working with the
Lawnmower
Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Run the equipment at a walking pace,
in tracks that are as even as possi-
ble. For gap-free mowing, the tracks
should always overlap by a few centi-
metres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
• Clean the equipment after each use,
as described in the chapter on "Clean-
ing, Maintenance and Storage".
Switch off the equipment after
work and in order to transport
it, disconnect the plug and wait
until the blade stops. There is a
risk of injury.
Cleaning, Maintenance
and Storage
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
GB
29