Operation; Inserting / Removing Grassbox; Adjusting The Cut Height; Switching On And Off - Grizzly Tools ERM 1500-33 LF Originalbetriebsanleitung

be turned clockwise for tension-
ing them or anti-clockwise to
loosen them
6. Clip the cable holder (12) into
the bar (3) and thus fix the ca-
ble. (11).

Operation

Inserting / removing grassbox

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of
1. To fit the grassbox (6), lift the
impact protection (5) and insert
the grassbox. Fold the collision
guard (5) onto the grass box
(6). It holds the grass box in the
correct position.
2. To remove the grassbox (6), lift
the impact protection (5) and
remove the grassbox. Fold the
collision guard (5) back onto the
mower housing (10).

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The mower can be adjusted by the inser-
tion of spacers (
cutting heights:
10 mm - Short cutting height
18 mm - Medium cutting height
25 mm - Medium cutting height
33 mm - Tall cutting height

.
injury..
19) to the following
1. Tilt the machine over
2. Using non-slip gloves, hold the
blade (18) firmly. Loosen the
blade bolt (17) with the supplied
spanner (4).
3. Depending on the desired cut-
ting height, click the spacers
(19) together. The more spacers
you use, the lower the cutting
height.
4. Removing the blade (18). Press
the required spacers into the
recesses provided on the blade.
5. Position the blade (18) on the
fan (20) with the inserted spac-
ers (19) upwards and connect
everything with the blade bolt
(17). Tighten with the spanner
( 4).
A higher cut height should be se-
lected for the first cut of the season.

Switching On and Off

1. Plug the mains lead into the ex-
tension cable outlet (13) at the
curved handle (1).
2. Turn the end of the mains lead
into a loop and hook it into the
cable strain relief (15).
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. Before switching on, tilt the
lawnmower slightly to one side.
This facilitates the start-up and
prevents an unintentionally
deep cutting circle at the point of
contact, as the air cushion only
builds up after start-up.
GB
65