Initial Operation; Operation; Mounting/Removing The Grass Box; Adjusting The Cut Height - Grizzly Tools ARM 2033-22 Lion Set Originalbetriebsanleitung

GB

Initial Operation

Before operating the machine,you must
- install the upper and lower upper han-
dles:
- install the collection bag
Caution! Risk of injury! During
the assembly or disassembly of
the collection bag, the engine
must be turned off and all mov-
ing parts must have come to a
standstill. Remove the battery
from the device before carrying
out any work.

Operation

Caution! Risk of injury! Always
wear appropriate protective
equipment and work gloves
while working with the appli-
ance. Prior to each use, ensure
that the appliance is working
correctly. Ensure that the col-
lection bag is installed correctly
and the device has been mount-
ed properly. Do not use the
device if a switch is damaged.
Personal protective equipment
and a fully functional appliance
reduce the risk of injuries and
accidents.
Adjustments on the mower, as
well as assembly and disas-
sembly of the collection basket,
mulch kit and lateral ejection
chute, etc. may only be made
while the motor is switched off
and the blades are at a stand-
still.
28
Switch off the device, remove the
safety key (
blade to come to a stop. There is a
risk of personal injury.
Observe noise control and local
regulations.
Mounting/removing the
grass box
1. To mount the grass catch box (13) lift
the impact protection (14) and mount
the grass catcher box (13).
2. Lower the collision guard (14) onto the
grass box (13) - it will keep it in place.
3. To remove the grass box (13), lift the
collision guard (14) and unhook the
grass box from the mounting bracket.
Flap down the collision guard to the
housing.
A level indicator is fitted on the
side of the grass bag.
Flap open:
grass catcher empty
Flap closed:
grass catcher full

Adjusting the Cut Height

There are 5 different cutting heights:
55 - 65 mm - large cutting height
40 - 55 mm - medium cutting height
25 - 40 mm - low cutting height
1. Hold the cutting height adjuster
(8) and move it to the correct
cutting height, as appropriate.
20) and wait for the