Inserting/Changing Batteries; Operation; Weighing - ADE KE 1602 Blanca Bedienungsanleitung

Inserting/changing batteries

In order to use the scales, you will need 2 batteries of type LR03 (AAA), 1.5 V (included).
The battery compartment is located on the underside of the device.
1. Press the locking tab slightly towards the centre of the scale and remove the battery
compartment lid marked with an arrow.
2. Insert the batteries as shown on the base of the battery compartment. Pay attention
to the correct polarity (+/-). Pay attention to the correct polarity (+/-).
3. Put the battery compartment cover back in place. The locking tab must snap
securely into place.
Notes on changing the battery:
‚ A change of batteries becomes necessary when "LO" appears on the
display, or when nothing at all is displayed.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Always change all batteries at the same time.
‚ Dispose of batteries in an environmentally appropriate way (see
"Disposal")

Operation

Weighing

1. Place the scales on an even, firm, and dry surface. Carefully position the scales in
order to avoid hard impacts to the sensors/feet and therefore to avoid damage.
2. Switch on the scale by briefly pressing down on the weighing platform using slight
force.
3. Keep pressing ZERO/MODE briefly to select the correct setting for your material to
be weighed. Note the display:
Solid material to be weighed
Weigh water
Weigh milk
To select a different unit of measure, press the UNIT button repeatedly. The
following units of measure are available:
‚ For solid material to be weighed: "g" (gram) and "lboz" (pound)
‚ For liquid material to be weighed: "ml" (millilitre) and "floz" (fluid
ounce).
Kitchen Scales KE 1602
Inserting/changing batteries
17