Prevent Damage From Chemical Supplies And Chemical Systems - Milnor 48040F7B Wartung

Figure 2: Safety Stands for Rubber Spring-resting, Hydraulic-tilt Washer-extractor Models
Install the safety stands as follows:
1. At the controls, tilt the machine as in normal operation. Tilt up only as far as needed to insert
the stands securely.
2. Referring to the figure, place the safety stands around the tilt cylinder shafts. Lock each stand
in position with the bolt, nut and washers provided. Always use both stands.
3. Lock out/tag out power to the machine.
BIWUUI06 (Published)
2.3. Prevent Damage From Chemical Supplies and Chemical
Systems
This document uses Simplified Technical English.
Learn more at http://www.asd-ste100.org.
®
All Milnor washer-extractors and CBW
specification. This material gives good performance when chemical supplies are correctly applied.
If chemical supplies are incorrectly applied, this material can be damaged. The damage can be
very bad and it can occur quickly.
Chemical supply companies usually:
• supply chemical pump systems that put the supplies in the machine,
• connect the chemical pump system to the machine,
• write wash formulas that control the chemical concentrations.
— End of BIUUUS06 —
Book specs- Dates: 20120917 / 20120917 / 20120917 Lang: ENG01 Applic: IHT
®
tunnel washers use stainless steel with the AISI 304
17
Chapter 2. Safety
PELLERIN MILNOR CORPORATION