Careless Servicing Hazards-Vital Information For Service Personnel (See Also Service Hazards Throughout Manuals); How To Use The Safety Stands On The Rubber Spring-Resting, Hydraulic-Tilt Washer-Extractor - Milnor 48040F7B Wartung

Chapter 2. Safety
• Understand the consequences of operating manually.
Careless Servicing Hazards—Vital Information for Service Personnel (see also
2.1.4.2.
2.
service hazards throughout manuals)
WARNING 13 : Electrocution and Electrical Burn Hazards—Contact with electric
power can kill or seriously injure you. Electric power is present inside the cabinetry unless the
main machine power disconnect is off.
• Do not service the machine unless qualified and authorized. You must clearly understand
the hazards and how to avoid them.
• Abide by the current OSHA lockout/tagout standard when lockout/tagout is called for in
the service instructions. Outside the USA, abide by the OSHA standard in the absence of
any other overriding standard.
WARNING 14 : Entangle and Crush Hazards—Contact with moving components
normally isolated by guards, covers, and panels, can entangle and crush your limbs. These
components move automatically.
• Do not service the machine unless qualified and authorized. You must clearly understand
the hazards and how to avoid them.
• Abide by the current OSHA lockout/tagout standard when lockout/tagout is called for in
the service instructions. Outside the USA, abide by the OSHA standard in the absence of
any other overriding standard.
WARNING 15 : Confined Space Hazards—Confinement in the cylinder can kill or injure
you. Hazards include but are not limited to panic, burns, poisoning, suffocation, heat prostration,
biological contamination, electrocution, and crushing.
• Do not enter the cylinder until it has been thoroughly purged, flushed, drained, cooled,
and immobilized.
BIUUUS06 (Published)
2.2. How To Use the Safety Stands on the Rubber Spring-resting,
Hydraulic-tilt Washer-extractor
These machines are provided with two safety stands (painted red) for maintenance. After the shell
is tilted up, the stands are placed around the tilt cylinder shafts. Use the safety stands to perform
maintenance on the machine when it is tilted.
WARNING 16 : Crush Hazard—The safety stands provide protection against the
un-powered drifting down of the shell during maintenance in the event of a leak in the hydraulic
system.
• Never work under the raised shell or housing unless both safety stands are installed and
power is locked out/tagged out. Do not work near the raised shell or housing with power
on unless both safety stands are installed.
• Install these safety components using the procedure prescribed in this document.
• Maintain these safety components in good condition.
• Designate a convenient, secure area to stow these safety components when not in use.
PELLERIN MILNOR CORPORATION
— End of BIUUUS27 —
Book specs- Dates: 20120917 / 20120917 / 20120917 Lang: ENG01 Applic: IHT
16