Newtec SAFE BI-1 Handbuch Seite 5

ATTENTION
The energy absorber with the lanyard can be equipped only with certified snap hooks
(according to EN 362). In order to avoid any accidental opening of the snap hooks, always
check that the gate is protected with the locking gear.
The fall arrest system must be connected to the structural anchor point complying with EN 795
standard or to a structural fixed point situated above the job place with a min. static resistance
of 15kN. The shape of the structural anchor point should not let self-acting disconnection of
the device.
The total length of a sub-system, including a lanyard, an energy absorber, terminations and
connectors, shall not exceed 2 m.
REQUIRED FREE DISTANCE BELOW WORKING SURFACE, WHEN WORKER IS PRO-
TECTED WITH AN ENERGY ABSORBER WITH LANYARD:
Drawings no.1, 2 and 3 show free distance below working surface depending on location of Structural Anchor Point, to which
energy absorber with lanyard is connected.
1
Structural
Anchor
Point
15 kN
3,5 m -
Free fall until
lanyard is in tension
1,2 m -
Ultimate
elongation of the
energy absorber
0,2 m - Displacement of
the back attaching ring
1,8 m -
Man height
+1 m -
Security
NOTES
Before using a fall arrest system, of which the energy absorber with lanyard is a component, you have to check that all devices
are correctly connected. They can work without any trouble and they are certified with the obligatory standards:
- EN 353-1, EN 353-2, EN 354, EN 355, EN 360, EN361, EN 362: for fall arrest system.
- EN 795: for anchor devices.
- EN 341: for descender devices.
USE
During use, the device should be protected from a contact with oils, acids, solvents, basics, open fire, hot metal drops and
sharp edges. You should avoid using the device in the dust laden and greasy environment.
WITHDRAWN FROM USE
The PPE must be withdrawn from use immediately when any doubt arises about its good condition or its right functioning.
Then it must be sent to the device manufacturer or to his certified representative to carry out a detailed inspection and to value
its eventual repair or destruction. If the PPE has been used to arrest a fall, it must be destroyed immediately.
PERIODIC REVIEWS
After each 12 months of utilization the PPE must be withdrawn from use for carrying out the periodic review.
During this inspection will be established admissible time for the PPE use till next periodic review. After this period, it is
strictly forbidden to use the PPE without carrying out next periodic review. All the information concerning the periodic review
must be recorded in the Identity Card. The periodic reviews and the updating of the Identity Card can be carried out by the
manufacturer or by his authorized representative only.
2
Structural
Anchor
Point
15 kN
2,0 m -
Free fall
until lanyard is in
tension
1,2 m -
Ultimate
elongation of the
energy absorber
0,2 m - Displacement of
the back attaching ring
1,8 m -
Man height
+1 m -
Security
cod.121133 - mod. SAFE BI - 1
Structural
3
Anchor
Point
15 kN
0,5 m -
Free fall until
lanyard is in tension
1,2 m - Ultimate
elongation of the
energy absorber
0,2 m - Displacement
of the back attaching ring
1,8 m -
Man height
+1 m -
Security