AEG DD 8796 Benutzerinformation Seite 69

• Fix the sides of the
cooker hood by
fastening the pins (10a)
to the sides of the
fastening screws (10b).
Block the sides sliding
the two tabs outwards
(11).
• Make electrical
connection (12), but
leave the hood
disconnected from the
home mains circuit.
• In the case that it is
decided to use the cooker
hood in the mains circuit,
then place one of the two flanges provided in the exit hole (13 –
Extraction). Attention! The tall flange should be used when a
telescopic chimney is required to be mounted (this item should be
ordered – see special accessories), the short flange is to be used in
all other cases.
• Remount the grease filter and the front panels according to the
numbering noted also on the back of each screen (from 1 to 4 from
the top to the bottom).
• Connect the hood to the home mains circuit and check if the hood
works properly.
1
14
2
3
4
12
Fig. 11
11
Fig. 10
Extraction mode
13
13
Recirculation
mode
10a
10b
69