RIBA RCP-10 Handbuch Seite 22

Tare function and Auto Tare
* The weight of any container can be tared by pressing a button so that with subsequent weighing the net
* weight of the object being weighed is always displayed:
* Place the empty tare container on the balance. The total weight of the tare container is displayed.
* Press "tare" key to start the taring process.
* Place the full tare container on the balance.
* You can now read the weight from the display.
* Press "tare" again to stop the taring process.
Automatic tare function :
* Press "tare" key for 5 seconds till the Arrow appears in the display
* If you switch the scale Off and On again, the Auto Tare is ereased
* After activate the Auto tare function, the first weight will be tared autom.
* Disable the auto tare function by pressing the Tare key for 5 sec.
* The arrow at the right in the display will be gone
Allways handle the scale with care, Don't shake the balance. This can harm the loadcell.
Remove the weight from the balance if you are done weighing.
Automatic switch off, yes or no:
Automatic switch off the scale, range 2 / 19 min.
* Switch On the scale and wait for standby
* Press NET/GROSS key and ON/ZERO
* In the display appears AoF xx ( xx Current time )
* Change the time with the ON/ZERO and NET/GROSS key
* Press 3 times TARE to confirm the setting
Switch On the scale and wait for standby
© RIBA WEEGTECHNIEK BV 19