Safety Instructions - Praher Plastics Aquastar Easy Bedienungsanleitung

Safety instructions

 This equipment has been built and examined according to safety precaution for electronic
devices and has left the plant in a perfect safety-related condition
 To keep this status and to guarantee a safe operation, the user must observe the safety
instructions, which are included in these instructions
 This installation work may only be undertaken by an authorized and licensed installer or
electrical business
 This equipment is not intended for it by persons (including children) with reduced physical,
sensory or mental abilities or for lack of experience and/or for lack of knowledge to be used it
is, it by a person responsible for their security is supervised or received from it instructions,
how the equipment is to be used. Children should be supervised, in order to guarantee that
they do not play with the equipment.
 This equipment has been built and examined according to safety precaution for electronic
devices and has left the plant in a perfect safety-related condition
 the electrical connection must have separating device built into the permanently installed
electrical installation, which enables the disconnection of all electrical contacts with a contact
space of min. 3 mm from the mains.
 Pay attention that the supply voltage is correctly protected and an earth-leakage circuit
breaker ≤ 30 mA is installed.
 Only use the equipment in dry rooms, in which no combustible gasses and vapors are present.
 Do not put the equipment into operation immediately if it has been taken from a cold to a
warm area. The thereby developing condensation water could destroy your equipment
 If the equipment has visible damages, does not work anymore or has been stored under
adverse conditions for longer periods, then it is to be expected that a safe operation is no
more possible. In this case the equipment is to be secured against unintentional start-up
and if necessary to be decommissioned.
 Live parts can be uncovered when opening the cover or removing parts. Before an alignment,
maintenance, a repair or change of parts or devices, the equipment must be separated from all
voltage supplies, if opening the equipment is necessary. If after that an alignment,
maintenance or a repair on the opened equipment under voltage is inevitable, it may only be
done by experienced, skilled staff, which has knowledge of the associated dangers and/or the
relevant regulations.
 Capacitors in the equipment can still be charged, even if the equipment is separated from all
voltage supplies.
 Assembly and/or disassembly of the valve only in a pressure-free status (i.e. empty piping
beforehand)
 Valve flow and/or direction of flow must be considered.
Each person involved in the operation and maintenance of the equipment must have
read and understood the present operation manual!
It is for your own safety!
6 www.praher-plastics.com