Heater In Installation - Sawo CUB3-45NB Handbuch

HEATER IN INSTALLATION

The heater can be placed wherever in the sauna, but for safety and convenience,
follow the minimum safety distances as provided below (See page 9). Follow the cubic
volumes given in the Technical Data (See page 28). Do not install the heater to the floor
or wall niche. Do not install more than one heater in a sauna room unless you follow
the special instructions for twin-heater installations. In most countries, there is a law
that requires heaters to be screwed to the floor.
The heater gets very hot. To avoid the risk of accidental contact with the heater,
it is recommended that a heater guard be provided.
The cable used for sauna wiring must be HO7RN-F type or its equivalent. A certified
electrician must do the installation of the heater to ensure safety and reliability.
Improper electrical connection can cause electric shock or fire. Refer to the electrical
diagram (See page 16).
WICHTIGER HINWEIS!
Entfernen Sie den Karton von den
Heizstäben, bevor Sie den Ofen instal-
lieren, da er nur zum Schutz während
des Transports dient.
Mindestsicherheitsabstände (mm)
Abb. 2
Fig. 2
Minimum safety distances (mm)
A
A
A
A
NOTE!
Remove the carton from the heating
elements before installing the heater
as it is only intended to protect them
during shipment.
A
CUB3-45NB
CUB3-60NB
CUB3-75NB
CUB3-90NB
CUB3-45NS
CUB3-60NS
CUB3-75NS
45
CUB3-90NS
A B
100 1900
100 1900
100 1900
125 1900
100 1900
100 1900
100 1900
125 1900
DEUTSCH | ENGLISH
9 9