Machine Information - Ferm HDM1028 Bersetzung Der Originalbetriebsanleitung

Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important
n that it is correctly destroyed and replaced by
an approved BS1363/13A fused plug and that
the following wiring instructions are followed.
with the The wires in the mains cable are coloured in
he accordance with the following code:
• b lue
• b rown
r rotary
As the colours of the wires in the mains cable
of the unit may not correspond to the coloured
oise can markings identifying the terminals in the plug,
proceed as follows:
• T he wire which is coloured blue must be
with the
connected to the terminal which is marked
onal injury. with the letter N or coloured black.
• T he wire which is coloured brown must be
ing
connected to the terminal which is marked
ration with the letter L or coloured red.
contact
ing Use of extension leads
ay make Only ever use approved extension leads that are
ol "live" suitable for the power rating of the machine. The
ic shock. minimum core thickness is 1.5 mm
using a reel extension lead, always fully unroll the
lead.
bserve the
untry to Immediately switch off the machine when:
d personal • E xcessive sparking of the carbon brushes.
ions and • I nterruption of the mains plug, mains lead or
mains lead damage.
• D efect switch.
of the • S moke or stench of scorched isolation.
he voltage

2. MACHINE INFORMATION

ation - You
Intended use
This rotary hammer is intended for drilling holes
in masonry such as brick, concrete and similar
tion is material. Furthermore, the machine can be used
ce (RCD) as a demolition hammer in combination with the
es the risk SDS cold chisels provided. The machine is on no
account intended for other purposes.
s
e replaced
similarly
ard.
HDM1028 Ma 1611-07.indd 5
Downloaded from www.Manualslib.com
neutral
live
. Whenever
2
Not suitable for construction site usage
manuals search engine
Technical specifications
Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. Drill diameter
-Concrete
-Steel
-Wood
Weight
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration
Hammer drilling concrete a ,
h HD
Chiseling a
h,Cheq
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN60745. It may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• U sing the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
• T he times when the tool is switched off or
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm and organizing your work
patterns.
230-240 V ~
50 Hz
850 W
900 /min
4000 /min
Ø 26 mm
Ø 13 mm
Ø 40 mm
4.6 kg
87.9dB(A)
K=3 dB(A)
98.9dB(A)
K=3 dB(A)
17.812m/s
2
K=1.5m/s
2
16.377 m/s
2
K=1.5m/s
2
5
23/11/16 16:35