Machine Information - Ferm HDM1038P Übersetzung Der Originalbetriebsanleitung

Use of extension leads
Only ever use approved extension leads that are
suitable for the power rating of the machine. The
minimum core thickness is 1.5 mm
using a reel extension lead, always fully unroll the
lead.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.

2. MACHINE INFORMATION

Intended use
This rotary hammer is intended for drilling holes
in masonry such as brick, concrete and similar
material. Furthermore, the machine can be used
as a demolition hammer in combination with the
SDS cold chisels provided. The machine is on no
account intended for other purposes.
Technical specifications
Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. Drill diameter
-Concrete
-Steel
-Wood
Weight
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration
Hammer drilling concrete a
h,HD
Chiseling a
h,Cheq
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN60745. It may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
. Whenever
2
• Using the tool for different applications, or with
• The times when the tool is switched off or
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. Left/right rotation switch
2. On/Off switch
4. Lock-on button
HDM1038P
5. Function selection switch
220-240 V ~
6. Side handle
7. Locking sleeve
50 Hz
8. Depth stop ruler
800 W
9. Depth stop button
0-1250 /min
0-5550 /min
3. OPERATING
Ø 26 mm
Ø 13 mm
Ø 30 mm
3.3kg
92 dB(A) K=3 dB (A)
103 dB(A) K=3 dB (A)
16.1 m/s K=1,5 m/s
2 2 Side handle
Fig. A
15.8 m/s K=1,5 m/s
2 2
The side handle (6) can be rotated 360° around
the drill head, enabling safe and comfortable
operation for both left and right-handed users.
• Loosen the handgrip by turning it
• Rotate the handgrip to the desired position.
different or poorly maintained accessories,
may significantly increase the exposure level.
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
Hammer drills require very little operator
pressure. Excessive pressure on the tool
can lead to unnecessary overheating of
the motor, and burning of the driven tool.
It also may happen the drill bit deforms
and cannot be removed from the
machine again.
anticlockwise.
5