Specifications - Makita DS4010 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Counterclockwise

SPECIFICATIONS

Capacities
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling in wood, metal and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Downloaded from www.Manualslib.com
Explanation of general view
2-2. Switch trigger
2-3. Clockwise
4-1. Drill chuck
Model
Steel
Wood
-1
No load speed (min )
Overall length
Net weight
Safety class
) : 81 dB(A)
pA
) : 92 dB(A)
WA
Wear ear protection
total value (tri-axial vector
2
) : 2.5 m/s or less
h,D
2
manuals search engine
DS4010
13 mm
36 mm
0 - 600
340 mm
2.8 kg
ENE032-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENF002-1
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENG102-3
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
ENG202-3
Designation of Machine:
Drill
sum)
Model No./ Type: DS4010, DS4011, DS5000
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
ENG901-1
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
6-1. Limit mark
7-1. Brush holder cap
7-2. Screwdriver
DS4011 DS5000
13 mm 16 mm
36 mm 36 mm
600
340 mm 348 mm
2.8 kg 3.0 kg
/II
Corporation as the responsible
600
ENH101-14