Philips hr1565 Handbuch Seite 10

EnglisH
10
mixing without the stand
1 Insert the beaters or kneading hooks into the mixer (follow the
procedure as described above at point 3 in section 'Mixing on the
stand').
2 Put the plug in the wall socket.
3 Lower the beaters or kneading hooks into the ingredients and
switch on the mixer.
Press the turbo button to mix more quickly or to increase the speed
during heavy jobs, e.g. kneading yeast dough.
For the right quantities and times, see the table 'Quantities and processing
times'.
4 If you want to stop mixing for a while, switch off the appliance and
put it (with the beaters or kneading hooks still attached) on its heel
until you continue (Fig. 10).
5 When you have finished mixing, set the control slide to 0 and
switch off the appliance. Then unplug the mixer.
6 Push the control slide forward to the eject position to release the
beaters or kneading hooks and remove them from the
mixer (Fig. 11).
cleaning
Always unplug the appliance before you clean it.
Never immerse the motor unit in water nor rinse it under the tap.
Caution: Do not use aggressive cleaning agents or abrasive cleaning
materials, such as scouring pads.
1 Clean the beaters, the kneading hooks and the spatula in warm
water with some washing up liquid or in the dishwasher.
2 Clean the bowl in warm water with some washing-up liquid.
03_064_5811_2_DFU-Booklet_A6_v1.indd 10 25-05-11 11:22