Tool Specifications; Declaration Of Conformity; Noise/Vibration Information; Mounting And Operation - Würth STP 150 POWER-S Originalbetriebsanleitung

Tool Specifications

The tool specifications of the machine are listed in the
table on page 183.
The values given are valid for a nominal voltage [U]
of 230 V. For different voltages and models for spe-
cific countries, these values can vary.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Tool Specifications" is in
conformity with the following standards or standardi-
zation documents: EN 60745 according to the provi-
sions of the directives 2011/65/EU, 2004/108/EC,
2006/42/EC.
Technical file (2006/42/EC) at:
Adolf Würth GmbH & Co. KG, Abt. PFW
74650 Künzelsau
T. Klenk
General Manager
Künzelsau: 30.01.2012
The following table indicates the action objectives for mounting and operation of the power tool. The instruc-
tions for each action objective are shown aside. Depending on the type of application, various instruction com-
binations are required. Observe the safety instructions.
Action
Inserting the Saw Blade
Ejecting the Saw Blade
Switching on the sawdust
blower device
Connecting the dust extraction
A. Kräutle
General Manager

Mounting and Operation

Noise/Vibration Information

The measured values of the machine are listed in the
table on page 183.
Noise and vibrational values (vector sum of three
directions) determined according to EN 60745.
The vibration emission level given in this information
sheet has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used to
compare one tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is
used for different applications, with different accesso-
ries or poorly maintained, the vibration emission may
differ. This may significantly increase the exposure
level over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool
is switched off or when it is running but not actually
doing the job. This may significantly reduce the expo-
sure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as: main-
tain the tool and the accessories, keep hands warm,
organise work patterns.
Figure Please observe
1
2
3
4
Page
184
184
184
185–186
15