Delete Transmitter Table In The Receiver - Selve commeo Timer BT Betriebsanleitung

GB
SELVE commeo radio
7.3. Delete transmitter table in the receiver
In case you programmed no longer existing transmitters in the
commeo Timer BT, you can delete the complete transmitter list of the
receiver. To do so, the commeo transmitter has to be in SELECT
mode and the corresponding commeo Timer BT has to be selected.
To delete the transmitter table in the receiver, push the
PROG button on the transmitter for 6 seconds. All trans-
mitters programmed in the receiver are deleted. The receiver
is still programmed in the transmitter. The programmed
6 s
receiver has been cancelled in the transmitter.
N ote: This causes an error message if there are any
more programmed receivers!
If this receiver in operating mode moves over a transmitter
which is still programmed, the transmitter will no longer
receive a response and will acknowledge this with an error
message.
In case further commeo transmitters have been programmed
in the commeo Timer BT, you will now receive an incorrect
feedback (red LED) when pressing the respective trans-
mitter. In order to fit this, you have to delete the receiver of
the corresponding transmitter as well!
48