Nordcap SKF 7F GN 2/1 Bedienungsanweisung Seite 71

WARNING! EXCESSIVE VARIATION OF THE
TEMPERATURE FROM OPENING THE DOOR
WARNING! THE CHAMBER TEMPERATURE
HAS NOT REACHED THE SET AT THE END
OF THE PRODUCT VERIFICATION PHASE
WARNING! EXCESSIVE DURATION OF
BLACKOUT, CHECK THE PRODUCT
WARNING! THE CHAMBER TEMPERATURE
IS DROPPING TOO SLOWLY, CHECK THE
PRODUCT
WARNING! HIGH TEMPERATURE IN CELL
WARNING! HIGH EVAPORATOR
TEMPERATURE
WARNING! THE DOOR IS OPEN, CLOSE THE
DOOR TO CONTINUE THE CYCLE IN
PROGRESS
WARNING! OPEN THE DOOR
WARNING! THE PROGRAM WAS
INTERRUPTED DUE TO A BLACKOUT AND IT
HAS BEEN RESTORED
WARNING! THE DEFROST PHASE WAS
INTERRUPTED DUE TO A BLACKOUT AND IT
HAS BEEN RESTORED
APPLIANCE
Rev. 01 of 01/07/2019
Translation of the original instructions in Italian
When the door was opened, the
temperature inside the cell changed
excessively, the cycle may have been
compromised.
The temperature has not been reached
within the established time, the quality of
the food may have been compromised.
The duration of the blackout was
excessive, check the products, the quality
of the food may have been compromised.
The temperature in the cell is dropping
too slowly, check the products, the
quality of the food may have been
compromised.
The temperature in the cell is too high.
The fault may involve the condensing
unit. Contact technical support.
Contact technical support.
Close the door, if the problem persists
contact technical support
Open the door
No action required
No action required
70
SOLL.