Information On Display Panel; Temperature Problem; Noise - NEFF GI7.13 Serie Gebrauchsanleitung

en Troubleshooting

Information on display panel

Fault
Message showing "D" or "E"
appears in the display.
Temperature display flashes. Different causes are pos-
The temperature display
flashes, a warning signal
sounds and lights up.

Temperature problem

Fault
The temperature differs
greatly from the setting.

Noise

Fault
Appliance has a humming
sound.
48
Cause
The electronics have detec-
ted a fault.
sible.
The appliance door is open.
The ventilation openings are
covered up.
Larger quantities of fresh
food have been put in.
Different causes are pos-
sible.
The appliance door is open.
The ventilation openings are
covered up.
Larger quantities of fresh
food have been put in.
Cause
Different causes are pos-
sible.
Cause
Not a fault. A motor is run-
ning, e.g. refrigerating unit,
fan.
troubleshooting
Call the after-sales service.
▶
→ "Customer Service", Page 51
Press .
▶
a The alarm is switched off.
Close the appliance door.
▶
Remove any obstructions from in
▶
front of the ventilation openings.
Do not exceed the max. freezing ca-
▶
pacity.
→ "Freezing capacity", Page 42
Press .
▶
a The alarm is switched off.
Close the appliance door.
▶
Remove any obstructions from in
▶
front of the ventilation openings.
Do not exceed the max. freezing ca-
▶
pacity.
→ "Freezing capacity", Page 42
troubleshooting
Switch off the appliance.
1.
→ Page 40
Switch the appliance back on after
2.
five minutes. → Page 40
If the temperature is too
‒
warm, check the temperature
again after a couple of hours.
If the temperature is too cold,
‒
check the temperature again
on the following day.
troubleshooting
No action required.