Save A New Loco - PIKO SmartControl light Kurzanleitung

light
While operating in the DC driving mode, you can increase the speed in one direction by turning the
throttle knob to the right. If you turn the wheel to the left the speed decreases until your train comes to
a halt. If you keep turning the wheel of the PIKO SmartController
accelerate into the other opposite direction.
If the top speed is reached, further turning of the wheel has no effect. While in this operating mode, a
gentle press on the wheel will stop the train immediately.
the up / down ([ / [
In the basic position, the keys
By pressing [ once, the number keys
By pressing [ again, you can control the functions F17 to F24.
By pressing [
The [ key will set back the selection of the special functions one step.
The [0
The displayed symbols show the respective function numbers and the current state of the special
functions so you can see which functions are turned on or off.
If you purchased a PIKO SmartControl
that was not part of a PIKO SmartControl
database of the PIKO SmartController

3.2. Save a new loco

You can save your own loco datasets in the loco database of the PIKO SmartController
can assign loco symbols, addresses, names and symbols for special functions. You can choose from
over 60 loco symbols and over 160 symbols for special functions.
numbers, that marks the decoder of a locomotive.
To illustrate the operating principle of the loco database, we give you an example of a
locomotive with the address "1234" on the following pictures.
By pressing and then
By pressing the throttle knob once, you can remove the warning note
"Mode=Cancelled".
By pressing , you reach the sub-menu 1 "LOCOADDR.". Here you can enter the above-mentioned
address by pressing
System
to
to will control the functions F9 to F16.
light
light
.
light
while in loco mode, the change loco data mode is selected.
22
to the left, the loco will start to
light
. Here you
light
[ .