Features - PIKO SmartControl light Kurzanleitung

light
PIKO SmartControl is a digital control system for both aspiring model railway beginners and
light
experts. It consists of the hand controller PIKO SmartController
PIKO SmartBox , which are connected via the enclosed spiral cable.
light
With PIKO SmartControl
light
enjoyable operation of a modest-sized digital model railway.
The PIKO SmartController
By using a PIKO #55044 Loco-Net converter it can also be used as an additional corded hand

Features

• With the digital central station, you can individually and simultaneously control up to 20
locomotives.
• You can individually set the data format for 9,999 locomotive addresses.
• You can control up to 24 special functions for each locomotive address.
data format, for example turnouts and signals.
• The states of the magnetic accessory addresses 1-1,024 are permanently saved, so that they
are displayed correctly after a reboot of the system.
• The PIKO SmartController
• The output of the main track of the digital station supplies a current of 2 A and is protected
against short circuits and overheating. This allows the simultaneous operation of up to 4 trains
• The digital central station is equipped with an extra output for a programming track with a
maximum current of 250 mA. During programming the output of the main track is switched off.
• With the digital central station, you can program DCC decoders as well as programmable
LocoNet ®
devices.
• The station also has a special output for a reverse loop relay.
• The digital central station is equipped with two LocoNet
System
you can control DCC locomotives, switch magnetic accessories
is the intelligent hand controller for the PIKO SmartControl
light
can memorize up to 16 different routes (each route can
light
and the digital central station
light
light
®
.
®
ports at the back.
system.