Operating The Piko Smartcontroller; Start - PIKO SmartControl light Kurzanleitung

mode
• Initiate loco selection or switch back to loco mode from every other mode
Keypad
• Number keys
operating mode and sub-menus
stop / delete
• Turn DC current on and off, delete last entered number or loco data set
Enter [

3. Operating the PIKO SmartController

3.1. Start

After starting-up your system, the PIKO SmartController
control a train with the PIKO SmartController
assigned name.
While in loco mode, you can start the selection of a locomotive by pressing on [lok or [
the throttle knob, you can select a locomotive out of the loco database (if there are any available
or [ . If the desired loco cannot be found on the list, you can enter a loco address with the keypad.
The [stop/delete key deletes the last-entered number and the
If you purchased your PIKO SmartControl
you can start your model train operation right away, due to the plug and play character of
the system. All locomotives of the starter-sets are already included in the database of the
PIKO SmartController .
light
Addresses of the trains included in the PIKO SmartControl
train address
electric loco 4
diesel loco 5
ICE 6
, enter loco address, switch into different modes, selection of the
change loco data mode
loco mode, turnouts mode and routes mode
programming mode
light
, you have to select it by its decoder address or the
light
system as part of a PIKO SmartControl
light
symbol function F0
light on/off
light on/off
light on/off
21
light
will be in loco mode. If you want to
and [
starter sets
light
function F6
switching mode
switching mode
switching mode
light
. By turning
[lok
starter-set,
light