Inserting And Connecting The Battery Block; Connecting The Power Pack And Charging The Battery; Block - Seca 727 Bedienungsanleitung Und Garantieerklärung

connecting the battery
Connecting the power
pack and charging the
58 •
Downloaded from www.Manualslib.com
for the power pack are located on the underside of the
scale.
Inserting and
1. Push the battery compartment latch in the direction

block

2. Remove the connecting cable from the battery
3. Connect the plug contacts of the connecting cable
4. Insert the battery block in the battery compartment.
5. Close the battery compartment.
battery block
1. Insert the power plug necessary for your power
2. Insert the device connector of the power pack in
3. Plug the power supply unit into a power supply
4. Leave the scale connected to the power supply for
manuals search engine
of the printed word "Battery" and flip open the lid.
compartment.
to the battery block supplied.
WARNING!
Personal injury and damage to device due to use
of incorrect power packs
The voltage supplied by standard power packs
may be higher than their indicated rating. This
may cause the scale to overheat, catch fire,
melt or short-circuit.
– Only use genuine seca plug-in power packs
with a controlled 12 V output voltage.
supply in the power pack.
the connecting socket in the base of the scale.
socket.
at least 24 hours when charging for the first time in
order to charge the battery block fully.