Specific Safety Instructions - Ferm MSM1040 Bersetzung Der Originalbetriebsanleitung

RADIAL MITRE SAW
MSM1040
Thank you for buying this Ferm product.
By doing so you now have an excellent product,
delivered by one of Europe's leading suppliers.
All products delivered to you by Ferm are
manufactured according to the highest standards
of performance and safety. As part of our
philosophy we also provide an excellent customer
service, backed by our comprehensive warranty.
We hope you will enjoy using this product for
many years to come.
1. SAFETY INSTRUCTIONS
Read the enclosed safety warnings,
the additional safety warnings and the
instructions. Failure to follow the safety
warnings and the instructions may result in
electric shock, fire and/or serious injury. Save the
safety warnings and the instructions for future
reference.
The following symbols are used in the user
manual or on the product:
Denotes risk of personal injury, loss of life
or damage to the tool in case of
nonobservance of the instruction in this
manual
Caution, risk of electric shock
Wear eye protection
Wear ear protectors. Exposure to noise
can cause hearing loss.
Wear a dust mask
Danger area! Keep hands, fingers or arms
away from this area.
Danger Area! Keep hands far away
(10cm) from the cutting area while the
machine is running. Danger of injury
when coming in conatct with the saw
blade
6
Do not direct the laser beam at persons or
animals and do not stare into the laser
beam yourself, not even from a distance.
This power tool produced laser class 2
laser radiation according to EN 60825-1.
This lead can lead to person being blinded
Disc dimensions. Observe the dimensions
of the saw blade.
Tranport the machine only when the
machine is in inward transport position

SPECIFIC SAFETY INSTRUCTIONS

• Mitre saws are intended to cut wood or
wood-like products, they cannot be used
with abrasive cut-off wheels for cutting
ferrous material such as bars, rods, studs,
etc. Abrasive dust causes moving parts such
as the lower guard to jam. Sparks from abrasive
cutting will burn the lower guard, the kerf insert
and other plastic parts.
• Use clamps to support the workpiece
whenever possible. If supporting the
workpiece by hand, you must always keep
your hand at least 100 mm from either side
of the saw blade. Do not use this saw to
cut pieces that are too small to be securely
clamped or held by hand. If your hand is
placed too close to the saw blade, there is an
increased risk of injury from blade contact.
• The workpiece must be stationary and
clamped or held against both the fence
and the table. Do not feed the workpiece
into the blade or cut "freehand" in any way.
Unrestrained or moving workpieces could be
thrown at high speeds, causing injury.
• Push the saw through the workpiece. Do not
pull the saw through the workpiece. To make
a cut, raise the saw head and pull it out over
the workpiece without cutting, start the
motor, press the saw head down and push
the saw through the workpiece. Cutting on
the pull stroke is likely to cause the saw blade
to climb on top of the workpiece and violently
throw the blade assembly towards the operator.
• Never cross your hand over the intended
line of cutting either in front or behind the
saw blade. Supporting the workpiece "cross
handed" i.e. holding the workpiece to the right
of the saw blade with your left hand or vice