Setting The Temperature; Switching O; Automatic Switch-O Time; Cleaning And Maintenance - Beurer HK 37 To Go Gebrauchsanweisung

WARNING
If the heat pad is being used over several hours, we recommend that
you set the lowest temperature setting to avoid overheating the heated
body part, which may lead to burns to the skin.
NOTE
When the powerbank (4) has been almost completely run down, the heat pad is switched o
automatically to protect the powerbank. The powerbank must then be charged.

4.6 Setting the temperature

OFF: On/O button (2) not lit
Setting 1: Minimum heat (LED display of the On/O button lights up green)
Setting 2: Medium heat (LED display of the On/O button lights up yellow)
Setting 3: Maximum heat (LED display of the On/O button lights up red)

4.7 Switching o

Press the On/O button (2) to switch o the heat pad (1). The switching sequence is 1 - 2 - 3 - OFF ... If the
heat pad is switched o , the LED display of the On/O button goes out immediately and the LED display on
the powerbank (4) goes out after a few seconds.
NOTE
Please note that the powerbank (4) must be protected against extreme cold to maintain its full
performance.

4.8 Automatic switch-o time

This heat pad (1) is equipped with an automatic switch-o function. This turns o the heat supply approx.
110 minutes after the initial use. The On/O button (2) on the heat pad and the white LED display on the
powerbank go out.
You can switch the heat pad on again immediately by pressing the On/O button. If it is no longer possible
to switch the heat pad on, then the powerbank has been run down.

5. Cleaning and maintenance

IMPORTANT
• Before cleaning, always first disconnect the powerbank (4) from the heat pad (1). Remove the pow-
erbank from the heat pad's pocket. Otherwise there is a risk of damage.
IMPORTANT
• The powerbank (4) must never come into contact with water or other liquids as this may cause
damage.
To clean the powerbank (4), use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
IMPORTANT
• Please note that the heat pad (1) must not be chemically cleaned, wrung out, tumble dried, put
through a mangle or ironed. Otherwise the heat pad may be damaged.
This heat pad is machine-washable. To do this, place the connecting cable (3) into the built-in pocket (5)
and place the heat pad (1) in a wash bag. Set the washing machine to a particularly gentle wash cycle at
30°C (wool cycle).
For ecological reasons, always wash the heat pad (1) together with other textiles.
Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
15