Step 3: Plan Hair Removal Using The Beurer Velvet Skin Pro For The Best Results - Beurer IPL 8800 Velvet Skin Pro Gebrauchsanweisung

1. Before the treatment, ensure that the skin is shaved, clean and dry (free from any residue such as
powder, cream, make-up, antiperspirant or deodorant).
WARNING
UNDER NO CIRCUMSTANCES should you clean the skin with flammable liquids such as alcohol
or acetone shortly before using the beurer Velvet Skin Pro.
2. Set up the device as described in Chapter 8.1 "Starting treatment" under points 2 to 5.
3. Place the light area of the device on the desired test area and make sure it is in full contact with the
skin.
4. The device is automatically set to the lowest energy level. Trigger the first pulse with energy level 1
by pressing the trigger button. You will see a bright flash, hear a cracking noise and may feel a slight
burning sensation and/or warmth. Within max. 3 seconds, the device is ready for the next pulse and
the indicator lamp on the beurer Velvet Skin Pro is continuously illuminated green.
5. Remove the light opening from the skin and place it on the next part of the test area.
Note
Only increase the energy level if the previous level is not uncomfortable for you. If energy level 1 is
uncomfortable for you, do not increase the energy level.
Note
Note: You can use the button for automatic skin tone detection to automatically determine the
recommended energy level for the respective treatment area. Make sure that the recommendation
is made based on your skin tone. You can adjust the energy level at any time.
6. The energy level can be increased by an increment of 1 by pressing the "+" energy level button.
The energy level indicator illuminates in accordance with the selected energy level.
Trigger the second pulse with energy level 2 by pressing the trigger button.
7. Only repeat steps 5 and 6 if you feel in good health, until you have reached the top energy level 6.
Stop the test if it feels uncomfortable, as there is a risk of adverse consequences if the energy level is
increased. Stop the test immediately if you notice adverse effects such as extreme reddening or blis-
tering.
8. Wait 48 hours and examine the treated area.
If the skin on the treated area appears normal (no reaction or slight reddening), you can continue with
the full treatment using the highest energy level that you found comfortable during the test. If you
notice extreme reddening, swelling or blistering even at a low energy level, do not perform a full treat-
ment on this area.
Note
Do not perform a full treatment with an energy level that you have not tested beforehand!
Do not treat the tested area until at least one week after performing the test.

STEP 3: Plan hair removal using the beurer Velvet Skin Pro for the best results

A typical hair growth cycle can last 18 – 24 months. During this time, several sessions using the beurer
Velvet Skin Pro may be necessary to achieve lasting hair removal. The effectiveness of the hair removal
differs from person to person and varies depending on the area of the body and hair colour, as well as
on how the beurer Velvet Skin Pro is used.
Typical hair removal plan using the beurer Velvet Skin Pro over a complete hair growth cycle:
• The first three to four hair removal sessions using the beurer Velvet Skin Pro should be performed
around two weeks apart.
33