NORAUTO 2207762/NO6700 Bedienungsanleitung Seite 81

f. For positive-grounded vehicle, connect NEGATIVE (BLACK) clamp from battery charger to NEGATIVE
(NEG, N, -) ungrounded post of battery. Connect POSITIVE (RED) clamp to vehicle chassis or engine
block away from battery. Do not connect clamp to carburetor, fuel lines, or sheet-metal body parts.
Connect to a heavy gage metal part of the frame or engine block.
g. When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then
remove clamp from battery terminal.
h. See operating instructions for length of charge information.
FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. A SPARK NEAR THE BATTERY
MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY:
a. Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a larger diameter than
NEGATIVE (NEG, N, -) post.
b. Connect POSITIVE (RED) charger clamp to POSITIVE (POS, P, +) post of battery.
c. Position yourself and free end of cable as far away from battery as possible - then connect NEGATIVE
(BLACK) charger clamp to free end of cable.
d. Do not face battery when making final connection.
e. When disconnecting charger, always do so in reverse sequence of connecting procedure and break
the first connection while as far away from battery as practical.
f. A marine (boat) battery must be removed and charged on shore. To charge it on board requires
equipment specially designed for marine use.
AC POWER CORD CONNECTION INSTRUCTIONS
The plug must be plugged into an outlet that is properly installed in accordance with all localcodes and
ordinances.
DANGER. Never alter AC cord or plug provided - if it will not fit outlet, have proper outlet installed by a
qualified electrician. Improper connection can result in a risk of an electric shock.
LENGTH OF CHARGE
The following instruction will allow you to determine how long it will take to bring a specific battery to full
charge.
a. Test the battery for state of charger with a hydrometer or electronic percent-of-charge tester.
b. Determine the size of the battery in Amp-Hour or Reserve Capacity. If the ratings are not printed on
the battery, contact your local battery dealer for this information. These are the only ratings that can be
used to determine length to charging time.
c. Use the battery rating, the charge level of the battery, and amp setting to be used on the charger in the
formula provided below.
Amp Hour Rating of Battery × Percent of Charged Needed
NOTE: The length of charge times are approximate and varies from the battery to battery.
Always follow the battery manufacturer's specific charging instructions.
CHARGING
NOTE: Before using the charger, please review all safety and connection directions. Failure to do so can
damage battery and cause serious injury or death.
• Connect the charger to battery per the operating instructions.
• Connect the charger to AC outlet.
• Select the appropriate charging mode for your batteries.
• If the charger does not detect a properly connected battery, the Reverse Polarity Indicator LED will light
or the Error Code will appear on LCD display until such a battery is detected. Charging will not begin
while the Reverse Polarity Indicator LED is on or the error code disappears. When the charging begins,
the charging process Icon on LCD display will appear.
Amp Setting Selected On Charger
80
× 1,3 = Hours to Charge