Hob Burner Control Knobs - Progress pag 6430 e Bedienungs- Und Installationsanleitung

Hob burner control knobs

Once the hob has been installed,
it is important to remove any
protective materials, which were
put on in the factory. The
manufacturer will not accept
liability,
instructions or any of the other
safety instructions incorporated in
this book be ignored.
The symbols on the knobs mean:
= no gas supply
= maximum gas supply
= minimum gas supply
For easier lighting, proceed before
putting a pan on the pan support.
Lighting the burners
To light a burner, turn the relevant knob
anticlockwise to maximum position and
push down the knob to ignite.
After lighting the flame, keep the knob
pushed down for about 5 seconds. This will
allow the "thermocouple" (Fig.1 - lett. D) to
be heated and the safety device to be
switched off, otherwise the gas supply would
be interrupted. Then, check the flame is
regular and adjust it as required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig.1 - lett. A) and
the"crown" (Fig.1 - lett. B) are in the correct
position.
In the absence of electricity, ignition can
occur without the electrical device; in this
case approach the burner with a flame, push
the relevant knob down and turn it anti-
clockwise until it reaches the "maximum"
position.
To switch off burners
To put the flame out, turn the knob to the
symbol ( ).
should the above
Triple crown
C
A - Burner cap
B - Burner crown
C - Ignition candle
D - Thermocouple
5
progress
A
B
D
Fig. 1