Progress pag 6430 e Bedienungs- Und Installationsanleitung Seite 16

16
progress
clamps, supplied with the injectors kit
(see diagram). When the fixing brackets
have been tightened, the excess seal
can be removed.
The overlaying sealing material should be
removed using a wooden or plastic knife
in order to avoid damaging the worktop.
To completely remove the sealing
material please position the plastic knife
at an angle (Position at an angle of 45°C).
The edge of the hob forms a double seal
which prevents the ingress of liquids.
a) seal
Fig. 7
a
Fig.8