Installation; Connection Cable; Before The Installation; Built-In Hobs - AEG HK624010FB Benutzerinformation

26 www.aeg.com
Problem
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

8. INSTALLATION

8.1 Before the installation

Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.

8.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in
Downloaded from www.Manualslib.com
and a number come on.
WARNING!
Refer to Safety chapters.
Serial number ...........................
manuals search engine
Possible cause
There is an error in the hob.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
units and work surfaces that align to the
standards.

8.3 Connection cable

• For a single phase or two phase
connection use the following (or
higher) mains cable type: H05V2V2-F
T min 90°C.
Remedy
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.