Electrical Connection - AEG HK624010FB Benutzerinformation

• The bottom of the appliance can get

2.2 Electrical Connection

• All electrical connections should be
• The appliance must be earthed.
• Before carrying out any operation
• Make sure that the electrical
• Make sure the appliance is installed
• Use the correct electricity mains
• Do not let the electricity mains cable
• Make sure that a shock protection is
• Use the strain relief clamp on the
• Make sure the mains cable or plug (if
• Do not use multi-plug adapters and
• Make sure not to cause damage to
• The shock protection of live and
• Connect the mains plug to the mains
Downloaded from www.Manualslib.com
between the bottom of the appliance
and the upper drawer, is sufficient for
air circulation.
hot. Make sure to install a non-
combustible separation panel under
the appliance to prevent access to the
bottom.
WARNING!
Risk of fire and electrical
shock.
made by a qualified electrician.
make sure that the appliance is
disconnected from the power supply.
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
correctly. Loose and incorrect
electricity mains cable or plug (if
applicable) can make the terminal
become too hot.
cable.
tangle.
installed.
cable.
applicable) does not touch the hot
appliance or hot cookware, when you
connect the appliance to the near
sockets
extension cables.
the mains plug (if applicable) or to the
mains cable. Contact our Authorised
Service Centre or an electrician to
change a damaged mains cable.
insulated parts must be fastened in
such a way that it cannot be removed
without tools.
socket only at the end of the
manuals search engine
installation. Make sure that there is
access to the mains plug after the
installation.
• If the mains socket is loose, do not
connect the mains plug.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
• Use only correct isolation devices: line
protecting cut-outs, fuses (screw type
fuses removed from the holder), earth
leakage trips and contactors.
• The electrical installation must have
an isolation device which lets you
disconnect the appliance from the
mains at all poles. The isolation
device must have a contact opening
width of minimum 3 mm.
2.3 Use
WARNING!
Risk of injury, burns and
electrical shock.
• Remove all the packaging, labelling
and protective film (if applicable)
before first use.
• Use this appliance in a household
environment.
• Do not change the specification of
this appliance.
• Make sure that the ventilation
openings are not blocked.
• Do not let the appliance stay
unattended during operation.
• Set the cooking zone to "off" after
each use.
• Do not put cutlery or saucepan lids on
the cooking zones. They can become
hot.
• Do not operate the appliance with
wet hands or when it has contact with
water.
• Do not use the appliance as a work
surface or as a storage surface.
• If the surface of the appliance is
cracked, disconnect immediately the
appliance from the power supply. This
to prevent an electrical shock.
• When you place food into hot oil, it
may splash.
WARNING!
Risk of fire and explosion
ENGLISH 19