Battery Test; Signals - Simons Voss Technologies ST10.08007S Kurzanleitung

MK/SI PinCode-Tastatur (on-
line)
6. Insert the new batteries with the positive pole facing upward
7. Carefully hook the battery clips back into the circuit board.
8. Replace the front of the housing.
9. Screw the two screws back in the bottom of the housing com-
9

8.1 Battery test

Perform a battery test every time that you replace the batteries. This
way, you ensure that the batteries used are fully functional.

9

9 Signals

Information on signaling the SmartIntego variant can also be found in
the SmartIntego TechGuide.
EN
(Murata, Panasonic or Varta CR2032 (3V) batteries).
pletely.
The batteries have been replaced.
Enter 000 000 1.
PIN code keypad signals the battery level (see
9. Signals
}
Signals [ 45] ).
45 / 180